GRRRR... Edge 2 stuttering

[theskipman_98]

Of course in the middle of a rush job and the gerber II starts "stuttering".

Seems to do it with the RUBY RED foil and GCS-GREEN onto Oracal 651 white, as a solid fill. ran 5 other colors on the job and others are fine. Our foils are a mix of Apex and Gerber.

Any suggestions?

Thanks in advance.

 

[Fred Weiss]

Set your job to Edge 1 settings to slow it down if you haven't already. Some foils just won't lay down correctly at Edge 2 speeds. if that doesn't do it, switch the job to a Gerber material.

We've used Oracal 651 for a lot of Edge printing but have had to return to 3M-Gerber material for some combinations of foils ... even on our Edge 1.

 

[theskipman_98]

Thanks Fred!

 

[theskipman_98]

Fred Thanks again rerunning the job and it is 100% better, not stuttering

 

[Fred Weiss]

Glad it was a helpful answer.