• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

GX-500 feed cal. for magnet?

Signed Out

Signed Out

New Member
My question is what feed calibration and blade offset should I use when doing print and cut on magnet... is there a magnet profile availible for versa works? if not PCV3 and change feed cal.?

xj 540 / gx 500 / vw rip / cs5
 
You must log in or register to reply here.
Top