• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Haunted plotter.....

N

Notlobdog

New Member
Hi folks. Turned my FC2100 on this morning ready to start a new job and it started cutting straight away!!??
Anyone know how to clear the internal cache on one of these? I've removed the blade and am just letting it run atm, but its been running for well over an hour now (the last job it did was 20mins of a task). What the *%^£ is going on? Any suggestions?
 
N

Notlobdog

New Member
Panic over. It ran for@ 3 hrs, but seems ok now. Still curious as to what caused it to do this.
(Found out how to clear the cache as well-DOH, proper Homer Simpson moment.)
 
You must log in or register to reply here.
Top