Grafxonlocation
New Member
Greetings fellow signmakers!
Please help!
I recently upgraded to relatively current technology in both software and my Apple Computer. However, my old Roland PNC 950 no longer communicates with it. I have used this cutter before with a serial to USB cable and a similar computer. The handshake is no longer working. I have bought a new cable, and this is not helping. Are the assignable pins on the side of the cutter (currently set to "off")a possible solution?
Any help in this matter pointing me in the right direction, would be of invaluable service!
Fraternally yours,
Stephen
Please help!
I recently upgraded to relatively current technology in both software and my Apple Computer. However, my old Roland PNC 950 no longer communicates with it. I have used this cutter before with a serial to USB cable and a similar computer. The handshake is no longer working. I have bought a new cable, and this is not helping. Are the assignable pins on the side of the cutter (currently set to "off")a possible solution?
Any help in this matter pointing me in the right direction, would be of invaluable service!
Fraternally yours,
Stephen
