Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hello there.Anyone with an Epson GS6000 printer with decoder and a multimeter ?

Discussion in 'General Chit-Chat' started by synksynk, Apr 4, 2019.

  1. synksynk

    synksynk New Member

    2
    0
    1
    Mar 30, 2019
    Romania
    Hello there,

    I am wondering if anyone here with a GS6000 printer with decoder (a multimeter, too) and also kind enough to take some simple continuity measurements. Trying to figure out the circuitry for such a device. There are just two pins can't figure out.

    Thank you very much !
     
  2. Slimoff

    Slimoff Member

    31
    0
    6
    Nov 13, 2013
    Belarus
    Hi,
    what exactly do you need to measure?
     
  3. synksynk

    synksynk New Member

    2
    0
    1
    Mar 30, 2019
    Romania
    Hello Slimoff, I am just trying to figure out the wiring. There are two wires going underneath the chip, that can't figure out where connected cause don't have such a board.
    Here's a schematic that illustrates where i am not so shure.

    https://ibb.co/P1rRSNj

    Thank you a lot !
     
Loading...

Share This Page

 


Loading...