HELP Adhesive all over Laminator Rollers

[KingsofWraps]

Lamination got stuck on bottom roll of laminator, after removing its FULL OF GLUE

What's the best way to clean this glue off I put goo off on but i literally have to scrape the whole crap off...any suggestions of
a liquid I can use and wipe right off with a cloth without burning to rollers?

 

[JERHEMI]

Rapid Remover?

 

[Christian @ 2CT Media]

We use alcohol but its supposedly bad for the rollers since it dries out the rubber.

 

[player]

I would try using some vinyl and quickly tap and remove the glue to glue. The glue on the roller should stick to the glue on the vinyl. Just do small areas at a time.

 

[ImagePress]

If this is a heated roller, best way I have found is to heat it and then use a belt sander cleaner (here's an example http://www.harborfreight.com/sanding-belt-cleaner-30766.html) takes a bit of elbow grease but it doesn't damage your rollers.

 

[eahicks]

If this is a heated roller, best way I have found is to heat it and then use a belt sander cleaner (here's an example http://www.harborfreight.com/sanding-belt-cleaner-30766.html) takes a bit of elbow grease but it doesn't damage your rollers.

LOL....had to reread...I thought you said take a belt sander to it....on RUBBER? Ha!

 

[thewvsignguy]

There is a laminator eraser by drytec that we use to remove the adhesive without damaging the rollers.

http://www.drytac.com/eraser-blocktm-1.html

 

[BIG EASY DOES IT]

There is a laminator eraser by drytec that we use to remove the adhesive without damaging the rollers.

http://www.drytac.com/eraser-blocktm-1.html

Your eraser is the exact same as the belt sander cleaner in a previous post. Can't see what the eraser cost from drytac as I am not a user. But I can see that the belt sander cleaner is only $8.00 from harbor freight.

 

[greysquirrel]

Use the eraser..