SignProPlus-Chip
New Member
Trying to tweak a custom shape and I cannot seem to generate a second control point off the node so I can round a point in both directions.
Anyone?
Anyone?
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
How do you pull TWO control points off a node?
- Thread starter SignProPlus-Chip
- Start date
J Hill Designs
New Member
right click on the problem line segment and change to curve?
not too good in flexi sorry
not too good in flexi sorry
Auburnpeanut
New Member
In flexi, both line segments on either side of the point have to be a curve for you to be able to pull a control on either side. If one side is a curve and one is a straight line then you will only be able to adjust the curve from one side of the point. Once you change both sides to a curve, you can adjust the curve as a cusp, smooth or symmetric.
Hope it helps!
Peanut
Hope it helps!
Peanut
Fred Weiss
Merchant Member
For future reference, at least in the terminology as I learned it, a node and a control point are the same thing. The arm that extends out from a node to control the length and angle of a curve is called a control handle.