HP L310 Measurements?

[303DC]

Can someone please tell me the depth of an HP L310? I'm looking for the front to back depth, without stand as if it were being carried in through a door. Also, is the width of 91" pretty accurate?

Thanks!

 

[Robert Gruner]

L310

width 90.8 in

depth 33.07 in

height 543 in

 

[J Hill Designs]

height 543 in

thats a MONSTER of a machine!!!

 

[Robert Gruner]

54.3 in height

 

[HIGHSPEEDGRAPHIX]

its a wide for a 54" media thats for sure, it is a front load media which is nice......in case the salesman didn't point it out, it takes two 220 volt sources, one for the printer and one for the heater and a 110 source of power for the take up, from what i was told....so yeah the ink is "green" but it seems like it takes alot more power to run it....

 

[303DC]

L310

width 90.8 in

depth 33.07 in
Y
height 543 in

I'm confused how it is 33" unpacked but 30" packed.

its a wide for a 54" media thats for sure, it is a front load media which is nice......in case the salesman didn't point it out, it takes two 220 volt sources, one for the printer and one for the heater and a 110 source of power for the take up, from what i was told....so yeah the ink is "green" but it seems like it takes alot more power to run it....

Yep, that's being installed this weekend. Thanks!

 

[P Wagner]

I'm confused how it is 33" unpacked but 30" packed.

The stand is assembled after unpacking, and the base of the stand are pieces that are 33 inches deep.

 

[303DC]

The stand is assembled after unpacking, and the base of the stand are pieces that are 33 inches deep.

Sounds like I'll be perfectly fine then since 33" was going to be a tight squeeze, if that depth is only the stand.