ill try explain what I mean, if someone could help it would be good. here we go, say if I had a template say a motocross graphic template just the outlines for were its got to be cut out, and I want to place graphic inside it like logos ect how would I do I without the logo still being outside the template. my esign/rip software is vinyl master expert, so its all new to me this software.
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
image inside a template help.
- Thread starter Bladey
- Start date
GAC05
Quit buggin' me
You need to find out how to mask a logo and then set up contour cut lines so they can be cut after print and lam.
Their training section sends you to a collection of youtube videos.
I think you'll need to go through a few to see what your software is capable of.
This one shows setting up contour paths
[video=youtube;2u2mll_eqbw]http://www.youtube.com/watch?v=2u2mll_eqbw[/video]
Looks like there are at least 60 videos to look at:
http://www.youtube.com/playlist?list=PLeA0HC8hNuPXcKMOhyeAVDs8oFFI24rV_
wayne k
guam usa
Their training section sends you to a collection of youtube videos.
I think you'll need to go through a few to see what your software is capable of.
This one shows setting up contour paths
[video=youtube;2u2mll_eqbw]http://www.youtube.com/watch?v=2u2mll_eqbw[/video]
Looks like there are at least 60 videos to look at:
http://www.youtube.com/playlist?list=PLeA0HC8hNuPXcKMOhyeAVDs8oFFI24rV_
wayne k
guam usa