Is this bad?

[timstudio]

This morning I noticed this message on my versacamm. I looked it up in the manual but couldn't find anything about it. Did anybody see this before?
I bought this versacamm on ebay from a farmer in Hungary. In the ad it wasn't mentioned what the machine was used for. I guess i do know now

 

[James Burke]

Baaaahhh! That's too funny.

 

[All Graphics Calgary]

Ewe got to be kidding me...:Big Laugh

 

[neato]

Wow. Looks like the seller pulled the wool over your eyes.

 

[GVP]

RAM error?

 

[vid]

RAM error?

...and that is troubleshooting at its finest.


That... that... that... >shaking head< was sheer genius. BRAVO.

 

[Baz]

Around here there is not a big market for Sheep.

But maybe for you it's a nice option to have

 

[Speedsterbeast]

You should re-title the post:
Is this Baaaaad?

Sorry

 

[T_K]

So, how often do you think you'd have to change blades? I'd hate to see what comes up when you try a contour cut!

 

[reQ]

:ROFLMAO: a very good one!

 

[JR's]

While the clutter is down you will probably have to farm your work out.

 

[All Graphics Calgary]

Have you herd from Roland? Careful, they may try and shear you...

 

[paul luszcz]

I don't have any sheep jokes, but I had the same problem with our Roland SC540. It kept getting worse until the misspellings were the least of our trouble. The screen became unreadable. It eventually only showed the right half of the screen. Twice. Once on the left side and repeating on the right.

I'd get it fixed before this happens if I were you.