is this feed calibration correct?

[bigkahuna_305]

im having issues with blurry print every other row. any thoughts?

 

[Solventinkjet]

You want the black squares to be touching without any overlap or gap. Input -0.55 and then print another pattern. It will be closer and then adjust from there.

 

[bigkahuna_305]

just did that and it printed much better just a little blurry on a couple spots above and below the design so adjusting it again and trying. will post a pic shortly. When i did reprint the test it showed 55 as touching and to the left they all looked the same its very weird

 

[bigkahuna_305]

You want the black squares to be touching without any overlap or gap. Input -0.55 and then print another pattern. It will be closer and then adjust from there.

so i did -55 and the next set they were all touching. i did a print and this is it now

 

[bigkahuna_305]

You want the black squares to be touching without any overlap or gap. Input -0.55 and then print another pattern. It will be closer and then adjust from there.

so now its the bottom of my designs that are having a miss print