• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Laminating on Flatbed Application Table

K

KapAg

New Member
Does anyone have problems laminating perforated vinyl with optically clear laminate on their flatbed table? I have a CWT table, and haven't been able to laminate my perf job without catastrophic wrinkles occurring. I have no problem with laminating anything else with our standard 2.5mil laminate...but the 1.5mil lam is causing me problems. Looking for any tips/tricks you might have.
Thanks in advance!
 
C

CanuckSigns

Active Member
Yes we find it tricky with thin laminates as well. We have found if you lower the pressure it helps, also if you have a second person help by holding the laminate and putting a slight tension on it will help.

We also have issues applying premask to cut graphics, especially if there is a lot of vinyl weeded away, we get wrinkles toward the end.
 
You must log in or register to reply here.
Top