We have used General Formulations for years and having issues with a recent batch of material we received. Trying to narrow down if it is material or printer issue. I believe it is a material issue but want to see if anybody else has seen this problem.
Material: Concept 201 & Concept 201OAP
Machine: Latex 360
Mode: 10 pass, 120 density
Optimizer: 12
The photo shows the difference from an older roll to a new roll we received. The weird part is we are seeing it on both batches of 201 and 201OAP that we received. Its almost like plasticizer migration or the ink is not being smoothly accepted across the media. Have 5 rolls of each material with each material having the same lot number that I would imagine was just produced.
Have tried adjusting the optimizer to 24, 34 with no better results. Any thoughts?
Material: Concept 201 & Concept 201OAP
Machine: Latex 360
Mode: 10 pass, 120 density
Optimizer: 12
The photo shows the difference from an older roll to a new roll we received. The weird part is we are seeing it on both batches of 201 and 201OAP that we received. Its almost like plasticizer migration or the ink is not being smoothly accepted across the media. Have 5 rolls of each material with each material having the same lot number that I would imagine was just produced.
Have tried adjusting the optimizer to 24, 34 with no better results. Any thoughts?