Looking for some help on pricing

[klingsdesigns]

Got a job for 30 semi trailers. Logo is about 39x138. Needs to be printed, lam, then cut, and premasked.
Logo will go on both sides.
Going to use ij180cv3-10 with 8518.

What would you charge for logo for each side? Does $400 seem about right?

If this was a one off sticker i would be around $645.

thanks!

 

[GAC05]

Seems reasonable to me, maybe bump it up a little.
That 39" plus extra for the crop marks will leave you with a 12" or so by 12ft long strip of waste off both the lam and 180c for each copy if you use 54" material.
I'd repurpose the scrap 180 & lam but it will take extra time to trim them out keeping them clean enough to run through the printer again.

wayne k
guam usa