Mac Illustrator CS driver for Roland CX-300?

[FatCat]

Hi guys, just purchased a Roland CX-300 from another member and am in the process of getting it set up. I would like to cut from Illustrator CS, on a Mac G5 using OS 10.3.

I found the updater on Roland's site to allow you to do this, however you already have to have the Roland Cutchoice software installed and running on your computer. The original roland install CD is formatted for OS 9 and the G5 will only run OS X. So I'm a little confused on how to get this installed in order to update it.

Can anyone point me in the right direction.:

 

[FatCat]

OK, since no responses to this question - who here is running a Roland cutter using Mac OS X? Are you using Roland's software or something else?