Magnetics

[signed off]

Hi all, I have 10 pieces of magnet cut to 15.5" x 10" ( vehicle grade gloss) all that is on it is one large number on each (using Avery premium 485 Red) My question is I have to box each set of ten ( 60 sets in total)
1) would you lay them back to front ( like how it is rolled when you get it)
2) front to front and stick something in between and than the next 2 front to front and so on
3) is there a better way to ship
hope I explained it
thanks

 

[ChicagoGraphics]

If it's cut vinyl I would just stack them on top of each other

 

[Fred Weiss]

Back to front with a piece of waste release liner between each.

 

[signed off]

that's one vote for each side. Do I have a tie breaker out there?

 

[player]

Back to front with a piece of waste release liner between each.

This is what I did last week.

 

[Marlene]

or just put some paper towels between

 

[2B]

Back to front with a piece of waste release liner between each.

+1

stack them, this method will allow the magnetic to "stick" to one another as the polarized sides will be +/- and the backing paper will protect the graphics in case there is movement

 

[MikeD]

definitely use some waste paper between them. If you don't there's a chance that they may get black marks on them from the back sliding over the preceding mag when you stack them

 

[Gino]

Release liner.

I would cut a piece the width of the job, by unlimited length and just wrap them overtop each other, shiny side up, like a butcher does your meat..... over and over and over, then tape the last piece.