Maximum size

[timstudio]

I have to print and cut several large format stickers with a dimension of 600 x 50cm. Can versa works and the sp300i handle these dimensions or do i have to cut in into smaller pieces?

 

[LFC911]

Per the media width specs from Roland on the SP300i 7.2 to 30 in (182 - 762 mm)

 

[timstudio]

The width is no problem. But I have never produced prints and cuts with a length of 6 meters. Not sure if it's possible.

 

[Mosh]

Print and cut will only be accurate for about 8' on that machine. And that depends on how close the cut and print are registered. If it is a close cut I only go 4'-6'.

 

[timstudio]

The cutout will be a simple rectangle of 600 x 50cm and 600 x 35cm. I need about six of each. Total over 70 meters.

 

[scrip]

I would do it with a nice ruler + x-acto

 

[DesireeM]

If you are going to print/cut at that length I would suggest making sure that your print feed calibration is setup for your print media. Long cuts will be more accurate - although I've never attempted a cut that long I've had pretty good results with approx 10ft print/cuts.

 

[timstudio]

Client called and asked for me to cut in 4 pieces each 150cm long. So problem solved