Mimaki cg-75 fx calibration

[MikeD]

the cutting is mis-registered to the print on the scan axis (B)
How do you get into service mode on this plotter?
Where is the adjustment for X/Y calibration (Mimaki calls it A axis and B axis.)

I had to make this same adjustment a couple years ago and forgot!

Thanks for your help!

 

[wunder]

you must hold 1 or 2 key and power on ! you remember ?!?!

have the keys in my office and will PM you in few hours

regards
wunder

 

[MikeD]

anyone know how to interpret the outcome of the 400mm.sq. test?

 

[MikeD]

I have drawn a test pattern to see how far off the print to cut registration is.
The cut is perfect along both axis on the control panel side of the feed axis. As the cut processes it's way to the opposite side of the platen it loses registration on both axis.
???????????????????????????????????????????????????????

 

[MikeD]

got a mimaki tech en-route... I will share the solution with you all as soon as I get it in hopes to avert aggravation of signs101 users that may experience this in the future.
MIkeD