Need Help Mimaki JFX200

[AJAJ]

I just reinstalled Rasterlink 6 in a new computer. When I'm ready to print, I get a message "The 2.5D texture maker profile is selected. Please select a profile again" I have tried different things to get this printing again, but I can't seem to get it going. Any suggestions???
Note: I have a Mimaki JFX200

 

[Greg Kelm]

I believe the EX model is only capable of the 2.5D Printing. I'm sure you have to change that setting and proceed from there.

 

[Solventinkjet]

When you installed Rasterlink did you also install any profiles?

 

[AJAJ]

I believe the EX model is only capable of the 2.5D Printing. I'm sure you have to change that setting and proceed from there.

You are right thanks for the input. I need a different profile.
do you know where I can download it from

 

[AJAJ]

When you installed Rasterlink did you also install any profiles?

No I did not. Where can I download some profiles from? for the Mimaki JFX200

 

[Solventinkjet]

Here is a link to the EX model profiles. Make sure to choose the right ink type!