mimaki jv3 250 sp

[Pagan]

hi ,this question is for all expert out there,
i have a jv3 250sp recently i change the main board
the printer does read media only on the right side, go all the way
to the left comes to the capping station read right of the media
again goes all the way to the left back to capping station then display error 50 media sense
any suggestion.
thanks Edwin

 

[Robert M]

main board

did you put your old firm ware on the board? It may think it is a JV3-160

 

[Pagan]

Mimaki jv3 250sp

I will check that tomorrow ,
I did change slide board,media sensor and cables
But no luck. My next step Firmware.
Thanks you

 

[Pagan]

Media sense error 50

I load firmware nothing happen still read right of the media
but not left of the media
help

 

[Tekkie1]

Its not the firmware but the original csv file and the same firmware that it had when the csv file was saved.
Tekkie1

 

[jaki514]

mimaki jv3 160-sp

Im having the same problem. did you guys figure this out yet? please help. thank you guys

 

[Pagan]

Mimaki jv3 250sp new problems

YES I INSTALLED csv file and the same firmware that it had when the csv file was saved. BINGO WORKS.
BUT A NEW PROBLEM ARRIVE . AFTER I INSTALLED CSV FILE. I TRY TO GET TO #ADJUST OR TRY TO INSTALLED NEW FIRMWARE
PRESSING FUNCION+ REMOTE OR <> NOTHING COMES UP , NO BEEPS . HELP