Mimaki JV33-160 parameter

[Elie]

Hello Guys,
I want parameter mimaki jv33-160 ss21 Firmware 5.70
I habe error X over current, yesterday I was printed no problem
today when turn on the printer i have this error
I checked all cables and reconnect cables

 

[Smoke_Jaguar]

Might be a jammed up motor pulling too much current and tripping the error.

 

[Elie]

I want to check the parameters first because i didn't have a new motor to test
Do you have

Might be a jammed up motor pulling too much current and tripping the error.

 

[Smoke_Jaguar]

See if you can turn the motor freely by hand with the power switched off.

 

[Robert M]

Wipe the encoder with a clean rag, look for ink spots on the encoder

 

[Elie]

See if you can turn the motor freely by hand with the power switched off.

Yes I tried, no problem it's soft freely

 

[Elie]

Wipe the encoder with a clean rag, look for ink spots on the encoder

It's X axis problem not Y motor
But also i tried that