We just replaced the heads, capping station and the lines on our Mutoh Falcon Jr. When we went to turn it on it came up with an e070 yencoder error. We checked the book to see what it said but it didn't really say much. Has anyone else had this happen before. We really appreciate any help. Thank you!
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Mutoh Falcon Jr e070 error
- Thread starter yamaha581
- Start date
Put the head in center of the carriage and then switch the machine on.
It should travel tot he right hand side to the cappingstation.
Tell us what happens....... further check this link....
http://www.signs101.com/forums/showthread.php?103543-Y-current-error-then&p=1085856#post1085856
Have look at this link.
10 to 1 the problem will be solved?
Let us know when it is not.
Paco
It should travel tot he right hand side to the cappingstation.
Tell us what happens....... further check this link....
http://www.signs101.com/forums/showthread.php?103543-Y-current-error-then&p=1085856#post1085856
Have look at this link.
10 to 1 the problem will be solved?
Let us know when it is not.
Paco
OK if it only moves in the middle a little it has nothing to do with the right hand side of the machine like capping and maintenance station.
When you replaced the head could it be that you loosened up one screw thath holds the carriage to the metal band?
Check if the height lever is moved (left side of the head) if the head really moves up and down.
Also you can temporary release some tension on the steel band on the left side of the machine and see what happens. Left cover need to be removed.
Paco
When you replaced the head could it be that you loosened up one screw thath holds the carriage to the metal band?
Check if the height lever is moved (left side of the head) if the head really moves up and down.
Also you can temporary release some tension on the steel band on the left side of the machine and see what happens. Left cover need to be removed.
Paco
We went ahead and tried all that but havent had any luck so far. We cleaned the sensor on the top of the head that a mutoh told us to check when we called. Now when we start the printer with the head in the middle it moves to the right about three inches. The only thing weve done was tighten the metal strip a little more.
J Hill Designs
New Member
If you look really closely at the encoder strip does it have ink or anything on it?