Question Mutoh VJ-1324 broken pinch roller holder

[simon haysom]

Hi there.
I can't see away of replacing this without pulling the whole machine apart. A major?. See attached photos. As you can see the plastic holder is broken. I tried glueing (It lasted about a week). Any tricks or thoughts much appreciated.
thanks Simon

 

[Subysti]

I don't have an answer but I have a VJ1324 you're welcome to take for parts worked fine when last it was used about 3 years ago. Switched to latex and haven't used it since. Also had mod installed to bypass ink chips. In CT. Oops. Just noticed your location.

 

[simon haysom]

I don't have an answer but I have a VJ1324 you're welcome to take for parts worked fine when last it was used about 3 years ago. Switched to latex and haven't used it since. Also had mod installed to bypass ink chips. In CT. Oops. Just noticed your location.

All good. I expected you head is stuffed if it's been sitting there for 3 years. I could be interested in purchasing the head if it had been flushed out thoroughly before going in storage, but a bit of a risk. ta Simon

 

[Subysti]

All good. I expected you head is stuffed if it's been sitting there for 3 years. I could be interested in purchasing the head if it had been flushed out thoroughly before going in storage, but a bit of a risk. ta Simon

It was all flushed before storage as I expected to continue using it or selling it at some point. I'm willing to give it away as who knows what may be living in it after this long. Most likely going to a recycling place soon.