• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

NEED HELP! LAMINATING 54" PROBLEMS

F

fresh

New Member
crny1 said:
Or has the laminator ran enough 30" material that the rollers are permanently smaller where the 30" has ran and thats the center area now with 54" and there isnt enough pressure in that area?
Click to expand...

I can attest to this happening to our laminator, i think we have the same as you. The rolls are slightly indented at 54" where the material is normally fed. We were having issues with it but then realized we just needed to reload the laminate an inch or so to one side so it grips again.
 
You must log in or register to reply here.
Top