• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Need Help

S

sweetpea35

New Member
I just did a test print to see how my nozzles were firing and k is fine
but c is half k and m is fine but y is orange like it has m in the y I don't even now were to start I'm using triangle bulk ink set up on a sp300v any suggestions would be greatly appreciated

Thanks
BAD DOG
GRAFFIXS
 
Ken

Ken

New Member
Soak the heads in cleaning fluid then do a couple of clean cycles.
Good luck!
Ken
 
You must log in or register to reply here.
Top