Ok So This might be a dumb ? but....

[ZsVinylInc]

Hey everyone...I am finally slowing down enough to put together some sales materials and one of them is going to be a proper PMS color chart that has been printed on my machine. I printed it on vinyl and banner material. I have since cut the banner material into 8.5 x 11" pages to go into a binder.

Is there anyway to seal the edges so that they don't fray at all? I tried using a heat gun but no luck. I have used a lighter in the past in a pinch for something just wondering what others are doing or if there is something else we can try. Any help or advice would be greatly appreciated.

 

[HaroldDesign]

Heat Knife
http://www.google.com/products/cata...ct=result&resnum=1&ved=0CBQQ8wIwAA#ps-sellers

 

[animenick65]

Small hem? Small piece of lam?

 

[ZsVinylInc]

Heat Knife
http://www.google.com/products/cata...ct=result&resnum=1&ved=0CBQQ8wIwAA#ps-sellers

So Caleb I assume you have used this before? Good Results?

 

[HaroldDesign]

So Caleb I assume you have used this before? Good Results?

I haven't, but a friend of mine has who said it worked well for him.
They're cheap enough to give a shot, I guess.

 

[Gino]

Haven't tried it, but how about nail polish remover ??

 

[ZsVinylInc]

Thanks...I googled it and found that a hardware place near me is suppose to carry it. If they do I am going to get one and will post the results later tonight.

 

[dlndesign]

banner tape, hem?