Onyx Thrive and Colex Marks

[mbasch]

We are attempting to stream line our workflow and use Thrive to generate the cut file for our Colex. It does, but it adds a ton of extra marks we don't need. We only want to have 3-4 per board. Does anyone know if there is a way to change how many marks Thrive adds to the board? Is there a config file we can hack?

 

[balstestrat]

You can usually change it in the cutter settings. File -> Manage Cutters

 

[C_support]

We are attempting to stream line our workflow and use Thrive to generate the cut file for our Colex. It does, but it adds a ton of extra marks we don't need. We only want to have 3-4 per board. Does anyone know if there is a way to change how many marks Thrive adds to the board? Is there a config file we can hack?

You can change the spacing for the reg. marks placing or you can set the Optiscout to read less marks.

 

[mbasch]

thank you.

 

[MGB_LE]

Is there any documentation to guide the optimizing of Colex and Onys working together? I overhear our Colex cutting out 25 graphics one at a time because prepress added dots for a 1-up print and my wide format operators nested and printed multiples of the file.

 

[C_support]

Is there any documentation to guide the optimizing of Colex and Onys working together? I overhear our Colex cutting out 25 graphics one at a time because prepress added dots for a 1-up print and my wide format operators nested and printed multiples of the file.

If you have 1 file printed with the "step and repeat" feature you can activate this feature at output to device. The software will read all copies and cut everything in one shot.

 

[MGB_LE]

If you have 1 file printed with the "step and repeat" feature you can activate this feature at output to device. The software will read all copies and cut everything in one shot.

If you have 1 file printed with the "step and repeat" feature you can activate this feature at output to device. The software will read all copies and cut everything in one shot.

Where would I find that option? My Sharpcut is from 2015 and I have CCC8 installed.

 

[C_support]

View attachment 176022

Where would I find that option? My Sharpcut is from 2015 and I have CCC8 installed.

Output to device menu. Number of copies - total number of files on the table. Then, copy options - set how many copes are in the X and Y directions and approximate spacing between them.