Onyx Thrive - Status Wait for media: Size

[Henrix Overcash]

When using Thrive Layout Tool after I setup and send the Print and Cut option the job sits in the Thrive que and says Wait for media: size. I use all of my normal printer, cutter, media etc is set the same as I normally run.

 

[SignMeUpGraphics]

With print and cut you need to ensure that there is enough room on either side for the cutter calibration marks.
For us that means only designing ~50" wide on a 54" roll.
Are you leaving enough room either side for those?

 

[cstone94]

On the right hand side where it shows what Media you have selected, it should have what the printable width is in parenthesis. You need to make sure the file you are printing is within that PW.