Need Help Oracal 651 vinyl and transfer paper problem

[Jamie Cook]

What in Gods name is going on? I’m weeding my transfer paper! Is it the vinyl or transfer paper! I just got back into this but have done it millions of times and this never happened?

 

[studio 440]

its been sitting to long and the transfer has bonded with the vinyl or it got wet

 

[Stacey K]

Your blade is set too deep, it's cutting the vinyl AND the paper. This happens to me sometimes if I forget to change the depth for cast/calendared. It sucks!

 

[Jamie Cook]

Your blade is set too deep, it's cutting the vinyl AND the paper. This happens to me sometimes if I forget to change the depth for cast/calendared. It sucks!

Now that makes sense! I just changed my blade so I’m hoping your right! Thank you so much!
Jamie

 

[Jamie Cook]

No wait a minute...it’s the transfer paper that’s coming off not the backing sheet???

 

[tbullo]

We have that happen sometimes right after a blade change. Just back off pressure a bit.

 

[Stacey K]

According to the photo the backing paper is sticking on the adhesive side of the vinyl. This is because you are cutting too deep into the vinyl and it's piercing the paper backing. I'll bet $100...set the depth to less and it will be fine.

 

[gabagoo]

New blades can be too sharp!!!

 

[Jamie Cook]

According to the photo the backing paper is sticking on the adhesive side of the vinyl. This is because you are cutting too deep into the vinyl and it's piercing the paper backing. I'll bet $100...set the depth to less and it will be fine.

Stacey your spot on ty! I went back and looked and I was wrong! I am cutting to deep! Ty to all of you for your response!

 

[Stacey K]

Stacey your spot on ty! I went back and looked and I was wrong! I am cutting to deep! Ty to all of you for your response!

I'm so happy you figured out!!! Great job!!!