Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

PNC-950 pen mode led error

Discussion in 'Roland' started by seliz, Apr 14, 2009.

  1. seliz

    seliz New Member

    1
    0
    0
    Apr 14, 2009
    :helpI have experimented turning the DIP switch SW-8 & 9 from off to
    on (per Roland's advice). Tried to cancel the error with the setup key.
    Moved the pinch rollers every-which-way and still cannot shake this pen mode. This has shut me down. Roland says my mainboard
    is shot another shop says it sounds like a sensor issue. I want to make
    darn sure before I spend more money.....any advice??

    This plotter is 12 yrs. old so maybe all good things do come to an end, but it sure has been a workhorse till now.
     
Loading...

Share This Page

 


Loading...