• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Post-print feed length on Roland VS-540

PRS Bryan

PRS Bryan

Member
Does anyone know how to adjust the amount of vinyl that is feed out after the print? I have a problem with the vinyl falling out when the printer is reading the rear registration marks. I am currently manually adding some additional length to the print before cutting. If I forget, then I place masking tape across the back edge to give the rollers something to grip when it is searching for the registration mark.

It is a minor issue but I was wondering if anyone knew if, and where the adjustment would be.

Thanks.
 
You must log in or register to reply here.
Top