Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Print and Cut

Discussion in 'Mutoh' started by amylynn@smartdesigns, Aug 6, 2007.

  1. amylynn@smartdesigns

    amylynn@smartdesigns New Member

    14
    0
    0
    Apr 3, 2007
    How do I print from my Mutoh then contour cut to my graphtec???
     
    Tags:
  2. VinylCraft

    VinylCraft Active Member

    732
    0
    0
    Sep 16, 2005
    Your going to have to give alittle more info than that. That software are you using. Do your print and then line up the reg marks in your plotter and set origan and your done.
     
  3. DRPSignsNGrafix

    DRPSignsNGrafix Very Active Member

    What software are you using
     
  4. amylynn@smartdesigns

    amylynn@smartdesigns New Member

    14
    0
    0
    Apr 3, 2007
    I am using flexi sign.
     
  5. amylynn@smartdesigns

    amylynn@smartdesigns New Member

    14
    0
    0
    Apr 3, 2007
    I have a Mutoh and I am using flexi sign and I would like to send my prints to a Graphtec FC 5100 - 100
     
  6. Bogie

    Bogie Very Active Member

    1,972
    0
    0
    May 17, 2007
    Helps if you already know how to curse and mutter under your breath...
     
Loading...

Share This Page

 


Loading...