printing to versaworks

[grafikguy]

I am trying to print a 52"x268" image to versaworks from photoshop. I am sending the file over at 72 dpi. What I get when it loads into versaworks is the trash icon beside the file and nothing about the file specifics. If I crop a portion of it, it will load, however and I can print that portion. This is a boat wrap, so I want it seamless. Is my file too wide to load up? Can I change any settings in versaworks to accommodate it?

 

[Bigdawg]

Verasworks 3 manual

There is a table about half way through that shows the limitations on file size and length.

 

[GVP]

Are you sending it as a pdf? I believe there is a 200" page size limit on pdf files - try sending as an eps?

 

[idsignsil]

Save it as a tiff and drag and drop into Versaworks

 

[Kentucky Wraps]

The trash icon is correctly labeling the Adobe file. JK

 

[T_K]

You can try saving it at 50% scale. When you pull it into VW, size it up 200% to get final print size.

Unless this is a very finely detailed image that will be viewed at 1 ft away, you shouldn't notice any issues.