Push/Pull Scale

[gplough]

Push/Pull Scale => Anyone have one of these collecting dust?

And if you're gonna say "just make one", what material did you use for the shim part? But I still think I'd rather just buy it... JS.

Thanks all!
Greg

 

[SignMeUpGraphics]

We use polypropylene pop-up banner material for the shim. Cut into a 1" wide strip, folded over 3 times at one end and installed an eyelet through it.
Doesn't cause damage to our laminator and has worked well for calibration for several years.

 

[FireSprint.com]

Are you talking about a force guage? Can you educate me on what this is you are talking about? Honestly, I have never heard of this I don't think...

 

[SignMeUpGraphics]

I believe we're talking about what's discussed in this thread:

https://signs101.com/threads/anywhere-know-where-i-can-find-this-push-pull-scale-attachment.145421/

 

[FireSprint.com]

That's kind of what I was thinking but wasn't 100% sure. Good luck!

 

[ChicagoGraphics]

3M sells those, maybe check Grimco or Fellers

 

[gplough]

ok, ok, I got this. That makes total sense and great idea. Didn't think about using that kind of material!

We use polypropylene pop-up banner material for the shim. Cut into a 1" wide strip, folded over 3 times at one end and installed an eyelet through it.
Doesn't cause damage to our laminator and has worked well for calibration for several years.