Rasterlink 6 pro & JV33 cleaning question

[Forty One]

I'm trying to find if there is a way to schedule a cleaning cycle either before or after a print for the JV33.
In the printer settings, the only 'scheduled' cleaning cycle is either Auto or Print and then the length can be dialed in. E.G. cleaning cycle after 2000mm etc, unless I'm missing something?

I've read through as much ofhte RL manual that I can stomache befer the japenglish really starts to do a number on my brain.
Chatgpt says that it is possible, but I can not find the tabs it is refferring to.

as I do large prints in this run, if it pauses to do a cleaning cycle mid print, it leaves a band. Hence why I want to schedule a clean either before or after each print.

 

[GraphixGirl79]

i came across an old thread started by you, and answered by hbb2008 in 2008. This is what he wrote:

you can do this by going into Function --> setup--> type--> Auto cleaning, down arrow to On or OFF and then when it is turned on, press Function to change the mm intervals.
OR
Function --> setup--> type--> print cleaning, THEN ,down arrow to On or OFF and then when it is turned on, press Function to change the mm intervals.


hope it helped.