• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

RBW-1500 question

C

crny1

New Member
Question regarding this welder. I know its not the best and have struggled since day 1 with it. Got it mostly sorted out and working except for some reason the banner will stick to the lower belt upon exiting and start to bunch up. Not every time but more often then not. I have turned the heat down thinking it was too hot and sticking to the belt causing it. Maybe I didnt go low enough? Anyone have this happen and were you ever able to remedy it? Thanks in advance.
 
D

Dan360

New Member
Happens on ours as well. I just keep pulling the leading edge as it passes through until it comes out the end.
 
You must log in or register to reply here.
Top