Recent VW update > problem

[Colin]

After downloading the recent automated update for VW, I have had an error message appear a few times when sending a job to print. It says something to the effect that "The job is larger than the media" or, "The Media is smaller than the job" (I can't remember the exact wording). But it seems odd that one would get this message given that VW gets the measurement of the media from the printer!

This occurred on jobs where I had entered many duplicates (in VW) of a small print & cut decal.

Anybody else experienced this?

 

[CS-SignSupply]

With our without registration marks?

 

[Colin]

If I recall correctly, one job was without, and one was with Print & Cut reg marks.

 

[mpn]

I have had this issue stepping in VW before, and it was the size of the art board on my original file(AI) and the distance between each image that was stepped. VW would step them outside the specified media range even though it was doing the measurements.

 

[Colin]

I had never experienced this until the recent update.

 

[splizaat]

i had the same problem and shut versaworks down, restarted it and it did just fine.