Return to Origin Point after printing?

[ScottyAdams]

Hey Guys,

A friend of ours just called us to ask a question that I'm not too sure about so I thought I'd ask you all and see if I cant get some help. Basically he wanted the image to print normally and then feed the media back and return to the origin point after the print completed. He forgot to choose this option before printing...is there anyway to get the media back to the origin point now at this point? Thanks!

 

[sfr table hockey]

If you had done a "sheet cut" just before the print, it would only feed back up to that point. If you loaded the paper, set up the printer then printed you may not know just how much of the media was pre fed.

 

[splizaat]

eeek....I usually load the vinyl then back the vinyl all the way back until it won't go any further. It's saved me a couple of times....I know that if a sheet of stickers stops printing for whatever reason halfway through, I can set to cut only and back the vinyl all the way back up and atleast salvage what's already printed...