• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Rockhopper 3 (spitfire?) print problem

M

mortil

New Member
Hi guys and girls.

i have a Rockhopper 3 that works great except one thing. when i get lots of yellow in a print i get banding in the printhead direction

sure it would be adjust printhead but the problem with that is when i enter maintenance mode and run the nozzle check it gets drips and misses lines.
it uses 6 colors and all printheads are replaced recently

do you folks have any suggestion on this ?
 
You must log in or register to reply here.
Top