Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rockhopper issue

Discussion in 'Mutoh' started by BobCap, Jun 22, 2012.

  1. BobCap

    BobCap Member

    186
    0
    16
    Jan 12, 2009
    Gilobert, MN
    I have a RH38 that started doing something different. The other guy that uses this printer "says" he didn't change any of the settings...

    When it boots up it sends about 3 or 4 feet of material through the printer, then it returns it back, and goes on as normal.

    I would think someone changed a setting...

    Any ideas?

    Thanks
     
    Tags:
  2. SlightlyChilled

    SlightlyChilled Very Active Member

    1,270
    0
    36
    Dec 19, 2009
    Hell
    He touched the roll /sheet button when the leaver was up if I recall
     
  3. BobCap

    BobCap Member

    186
    0
    16
    Jan 12, 2009
    Gilobert, MN
    Spot right on!

    Duh, the led was looking right at me...
     
  4. SlightlyChilled

    SlightlyChilled Very Active Member

    1,270
    0
    36
    Dec 19, 2009
    Hell
    I did the samething. One time drove me nuts till it put the button cover back on.
     
Loading...

Share This Page

 


Loading...