Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Roland CX-24 problem

Discussion in 'Roland' started by snapper, Aug 22, 2005.

  1. snapper

    snapper New Member

    Aug 22, 2005
    For the last year or so, the cutter would quit but start again if I wiggled the serial cable near the computer. Now it quit for good. Talked to a tech guy and he says that the serial cable could be bad and that they are unique to Roland - you can't go to the computer store and buy one off the shelf. Any comments?
  2. OldPaint

    OldPaint Major Contributor

    try a new cable..OFFICE DEPOT/STAPLES

Share This Page