Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Roland sj500 dummies guide

Discussion in 'RIP Software & Color Management' started by westride, Nov 17, 2019.

Tags:
  1. westride

    westride New Member

    4
    0
    1
    Dec 6, 2007
    Bideford
    Please can anyone add a simple installation guide I have purchased all types of software since my hard drive broke and spent hours looking online but can’t find “a simple what software and setup “ to get the cutter working .and if poss basic instructions . Thanks
     
    Tags:
  2. jimdtg

    jimdtg Member

    227
    19
    18
    Jun 18, 2017
    Some places in earth
    What software did you install and use before hdd was gone?
     
  3. woolly

    woolly Active Member

    623
    16
    18
    Sep 24, 2007
    Cornwall uk
  4. westride

    westride New Member

    4
    0
    1
    Dec 6, 2007
    Bideford
    not sure , but when we had it working it was an old coral draw. it was already set up we just used the red contour cut line and sent to print it then cut as required. We now have windows xp and an old coral draw and then added software that we got emailed from roland as no downloads available from their Web sight . colourchoice and firmware. the only difference is the new laptop only has usb so we added a usb to serial lead. but believe it may just need the correct settings in coral to send to Rip software?
     
Loading...

Share This Page

 


Loading...