Roland SOLJET SC-545EX

[person'ize it]

Hi anybody know where to locate the jumper to reset the password to enter my service mode on my
SOLJET SC-545EX Thanks

 

[FrankW]

There is no individual password, there is a standard key combination which is the same for all machines (there are two variations depending on the firmware version).

Latest version is with arrow keys

down right left up down right left - than hold down right left and switch on the printer

 

[person'ize it]

Hi Frank, thanks for reply once gone through arrow sequence it asks for a passcode

 

[netsol]

we just replaced heads in ours yesterday
if you do the sequence incorrectly, it says setup protected.
this is not a request for a password

roland protected the service menu like it is the nuclear launch codes
then they did a crappy job of explaining the sequence

 

[person'ize it]

we just replaced heads in ours yesterday
if you do the sequence incorrectly, it says setup protected.
this is not a request for a password

roland protected the service menu like it is the nuclear launch codes
then they did a crappy job of explaining the sequence

Great i,ll try again tomorrow, thanks

 

[eahicks]

There is no individual password, there is a standard key combination which is the same for all machines (there are two variations depending on the firmware version).

Latest version is with arrow keys

down right left up down right left - than hold down right left and switch on the printer

And if you do down right left up down right left - circle square circle square you get unlimited lives!