roland sp300-Temp to low

[stillhasdust]

Whenever I turn on my machine is says "temp to low" and continues to beep..Does any one have any suggestions

 

[kustomkoncepts]

turn off main power rocker switch and then on and then secondary power.

what does it do then?

I never got the low temp error before but I have got a (((heater voltage error)))

about 10 times in 4 years I just turn off and restart and works.

 

[kustomkoncepts]

is this when you turn on the printer in the morning or when it is sitting idle and then you send a print file to it?

 

[Mike Paul]

How cold is the room?

 

[CS-SignSupply]

Either too cold in the room or possibly thermistor cable. Seen this in many warehouse environments.

 

[Mike Paul]

I never got the low temp error before but I have got a (((heater voltage error))) about 10 times in 4 years I just turn off and restart and works.

Same here, only happens in the winter.

 

[Tony McD]

Same as Kustom here, I never got the low temp error before but I have got the heater voltage error. The shop was cold, and when I turned the office heat up it started like normal. It was like the cold room "freaked" the printer out.

 

[CS-SignSupply]

Error is there by design.

Operation Temperature: 15 to 32 degrees C (59 to 90 degrees F )
(20 degrees C [68 degrees F ] or more recommended),
Humidity: 35 to 80% (no condensation)