Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Roland VG error Codes?

Discussion in 'Roland' started by tim99, Sep 4, 2018.

  1. tim99

    tim99 Member

    136
    11
    18
    Jun 9, 2013
    general
    Anyone know the VG error codes.. occasionally get Service call 0109
     
    Tags:
  2. Solventinkjet

    Solventinkjet DIY Printer Fixing Guide

    3,832
    686
    113
    Aug 2, 2011
    Denver, CO
    I don't have that tech manual yet but the 0109 on other Roland printers means that wiper origin sensor did not detect the wiper returning properly. I would say your wiper is either jammed or the sensor is malfunctioning.
     
  3. Joe House

    Joe House Active Member

    868
    184
    43
    Feb 5, 2004
    WA
    Yup, 0109 is the same on the TruVis printers. Do a hard shut down, front and back and let it sit unplugged for a few minutes then keep an eye on the wiper when you boot back up. It should reset itself. If it passes that ok, then try to run a normal cleaning and keep an eye on the wiper. See if you can determine when it fails, if it continues to fail. Does the wiper move at all? Is the carriage getting in the way of the wiper when it tries to move? This wiper system is less susceptible to getting gunked up than older ones were.

    Let us know what you find out.
     
Loading...

Share This Page

 


Loading...