Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Roland XC540 Motor error

Discussion in 'Roland' started by txsurfer, Oct 20, 2010.

  1. txsurfer

    txsurfer Member

    284
    0
    16
    Oct 29, 2005
    Texas
    We had a head strike on Banner Material
    Motor Error Turn Power Off/ Scan Motor error code: 0010 0010
    any help would be appreciated.
     
    Tags:
  2. txsurfer

    txsurfer Member

    284
    0
    16
    Oct 29, 2005
    Texas
    bump
     
  3. Thoughts on the scan motor error...

    Must have been a real good strike...

    Scan motor deviation error. The machine is very confused right now. The servo in the scan motor is sending information that does not jive with what the mainboard is expecting.


    1. Turn off the main power. Unplug the machine for a minute or two. Press the front power button a few time with the machine unplugged.
    2. Make the the cut carriage/print carriage are connected, and pushed over all the way to the right to the capping position.
    3. Plug in the machine. Turn on main power, then front power.

    Still have problems? Then you may need to to a Limit Initialize. Let me know and I'll go through the procedure.

    ~E
     
  4. txsurfer

    txsurfer Member

    284
    0
    16
    Oct 29, 2005
    Texas
    Tried it still getting scan motor error, turn power off. It was a good Strike!
     
Loading...

Share This Page

 


Loading...