/ Register

Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Servo Board

Discussion in 'Roland' started by mikestickers, Sep 13, 2019.

  1. Sep 13, 2019 #1
    mikestickers

    mikestickers Chief, Cook and Dish Washer!

    34
    1
    8
    Mar 22, 2016
    Gulfport, MS
    Anyone know anything about SP540v and SP300v Roland printers?

    I have a Roland SP300v and when I came home from vacation the printer would not come on. SO I sent the mother board in thinking it was that. Nope, So I also have an SP540v basically the same printer so I borrowed / swapped out the panel cable on the 300v thinking it was the cable but no, then I swapped out the power supply and not that either. No green LED on the servo or heater board.

    I didn't swap out the servo board in fear that if it a servo motor if bad may blow out the servo board (that I burrow) off the 540v....

    Any suggestions?
     
    Tags:
Loading...
Similar Threads - Servo Board
  1. Impact Color

    Need Help Question How to perf cut on a Roland Camm-1 Servo GX-24

    Impact Color, Dec 21, 2020, in forum: Roland
    Replies:
    5
    Views:
    349
    Jester
    Dec 26, 2020
  2. erdrich kalisky

    Need Help looking for Colorado oce 1640 servo drive

    erdrich kalisky, Nov 26, 2020, in forum: Miscellaneous Printers
    Replies:
    3
    Views:
    434
    Bert Wondervan
    Nov 26, 2020
  3. Little Linda

    PA Need servodrive motor for older roll to roll solvent printer: Emotion Tango-A02

    Little Linda, Aug 17, 2020, in forum: Member to Member Classifieds • Wanted To Buy
    Replies:
    0
    Views:
    620
    Little Linda
    Aug 17, 2020
  4. Eddie Greer

    Moving Mainboard from a Vj-1204 to a VJ-1304

    Eddie Greer, Dec 9, 2020, in forum: Mutoh
    Replies:
    4
    Views:
    476
    7_nebo_7
    Dec 12, 2020
  5. Annette Asberg

    Need Help Project board

    Annette Asberg, Nov 24, 2020, in forum: Installation Equipment & Techniques
    Replies:
    11
    Views:
    656
    ColorCrest
    Nov 25, 2020

Share This Page


XenPorta 2 PRO © Jason Axelrod from 8WAYRUN

 


Loading...