Setting to correct letter cutlines not perfect

[hotboxdp]

I have a FC5100-100. Great plotter! Recently the inside & outside of some letters aren't connecting properly. I've attached a picture. What setting do I need to adjust to correct this? Thank you.

 

[Boudica]

Try slowing it down... that usually fixes it for me on our Summa. I also turn it off, and then back on (summa get's glitchy sometimes, but a reset usually solves the problem)

 

[JBurton]

Did you accidently change the blade type in the settings? I don't recall the 'standard' blade for most vinyls, but it takes just a second of monkeying in the settings to change by mistake, and it often looks about like that.

 

[Broome Signs]

Look at the cutter offset and quality setting of the plotter
are you using aftermarket cutters? if so go back to the original and compare the cut