Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sheet Cut button

Discussion in 'Tips & Tricks' started by Belmont, Sep 14, 2012.

  1. Belmont

    Belmont New Member

    2
    0
    0
    Sep 13, 2012
    Hey guys... just wondering, has anybody out there run into this problem... the sheet cut button on the control pad doesn't work anymore? It was workin yesterday but for some reason when I hold the button down now, it doesn't beep and run across the width and and run back cutting the print that was just done.
    If anybody has any ideas, it would greatly help!
    Thx
    Dave

    Roland SP 540v - VersaWorks

    :peace!:
     
    Tags:
  2. kanini

    kanini Member

    402
    14
    18
    Jul 13, 2012
    Finland
    You haven't set your media clamps to "long"? Don't know if it gives a message then or not but doesn't that disable the sheet cut function? Or am I totally wrong (I have the SP-540i so it could be different).
     
  3. Belmont

    Belmont New Member

    2
    0
    0
    Sep 13, 2012
    Kanini, you were right! Media clamps were set at " long ". Changed that and all back to normal!
    Thx a bunch!
    Dave

    :thankyou:
     
Loading...

Share This Page

 


Loading...