Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Signlab and Mutoh 64 bit drivers????

Discussion in 'Signlab' started by Slack11, Oct 13, 2009.

  1. Slack11

    Slack11 Member

    120
    0
    0
    Jul 28, 2005
    Just bought a new computer with Vista (64bit) system. I am currently running signlab v7.1 which runs on the machine, but I cannot send any prints to the printer. The program acts as if it is sending a job (like my old computer) but it seems as if the printer can't accept it.

    Is there a special driver to use with vista for the Mutoh printers? I installed the printer from the software from signlab, but I am sure that the driver on that disk is for an older 32 bit system. Again, it seems as if everything else is working right.
    <!-- / message -->
    <!-- controls -->[​IMG]
     
    Tags:
  2. xpressgraphixman

    xpressgraphixman New Member

    21
    0
    0
    Mar 2, 2009
    Did you update the IP adress?
     
  3. d fleming

    d fleming Very Active Member

    2,804
    238
    63
    Nov 28, 2007
    Middleburg, Florida
    Try going to cadlink.com to see if there is an updated set of drivers for vista?
     
Loading...

Share This Page

 


Loading...